REMS Tool Servicing & Calibration

Tool Calibration

Includes Certificate We run diagnostics on the tool & check press force measurements

Jaw Calibration

Includes Visual Inspection & Report Please note: We are only able to supply jaw springs for Akku Press. Springs for the Mini Press are not available as separate items

Service

Includes Calibration & Certificate, Labour, Parts Kit (Back-Up Rings, Locking Rings, O-Rings, & Piston Kit) & Re-Grease

Repair

Includes a service along with Block Replacement. Requirement for repair can only be established on completion of the service at the point of test/calibration

Enquiry

Call us on 02380 315316 or use the form below for servicing/repair pricing and to inform us you’re sending your tool/jaws in

Send

Send your tool to us to inspect either by post (click here for our address) or you can pop in and visit us. When sending in your tool, please print off your copy of the booking form and send it with the tool

Assessment & Inspection

Your tool/jaws will be visually assessed and diagnostics run to check for any faults

Repair/Service Quote

You will then be contacted for the cost of your repair/service. If you are happy with the price of repair/service, we would ask if you could confirm this by email or phone

Tool Repaired/Serviced

After receiving confirmation, your repair will be carried out. Most parts are usually in stock however we do have to order some parts in therefore cannot guarantee a timescale on repairs

Test & Final Inspection

After the repair/service is carried out, your tool will be tested and inspected to make sure it is working correctly

Return

After the tool has been repaired and tested we can arrange for your tool to be picked up or posted to you which will include a carriage charge